DRYWALL INSTALLATION IN SOUTHERN CALIFORNIA

What a full installation includes

Installation is more than screwing board to studs. Every job we hang is planned around board layout, fastener spacing, and joint placement so the finished wall stays flat and crack-free as the framing moves and settles.

• Layout and board takeoff so seams land away from door and window corners
• Hanging ceilings first, then walls, with staggered joints and minimal butt seams
• Correct fastener type and spacing for framing, and screws set below the paper without breaking it
• Taping with paper or mesh tape, then two to three coats of joint compound
• Sanding, dust cleanup, and a walkthrough under bright light before we call it done

Choosing the right board

The right panel depends on the room and the assembly. We install the board the plan or the condition calls for, and we tell you why.

• 1/2" standard board for typical walls, 5/8" Type X where fire-rated assemblies are specified
• Moisture-resistant and cement board in bathrooms, laundry rooms, and behind tile
• Sag-resistant ceiling board for 24" on-center ceiling framing
• Sound-rated assemblies with resilient channel, double layers, or damping compound for bedrooms, offices, and shared walls

High, vaulted, and complex ceilings

A large amount of our work is ceilings other crews avoid: two-story great rooms, vaulted and coffered ceilings, curved archways, soffits, and skylight returns. We bring scaffolding, stilts, and lifts, and we build the radius and transitions in place so the geometry reads clean from the floor.

How we keep the job clean and on schedule

We protect floors and finished surfaces, keep board scrap stacked and hauled out, and sequence work so other trades are not standing around. If your project depends on inspection timing, tell us up front and we schedule around it.